Jump to: navigation, search

Difference between revisions of "Main Page"

m (HowTo)
(HowTo)
Line 30: Line 30:
 
* [[BLTouch | Using BLTouch with Replicape]]
 
* [[BLTouch | Using BLTouch with Replicape]]
 
* [[Adding a Servo | Adding a Servo to Replicape]]
 
* [[Adding a Servo | Adding a Servo to Replicape]]
 +
* [[Probing | Probing for G29/G33]]
 
* [[SSH Commands]]
 
* [[SSH Commands]]
 
* [[Faq]]
 
* [[Faq]]

Revision as of 21:26, 2 October 2018


Thing printer is a development platform for electronics and software made by Intelligent Agent. All software is free and open source. The hardware is also open source, but can be conveniently purchased in the store.

This is the thing wiki. It has a lot of info about Replicape, Manga Screen, Redeem, Kamikaze and Reach.

NEW DOCUMENTATION!

Completed reorganized! Updated getting started guide. Wiring diagram and specs. And ability for different versions of the documentation!

Replicape Documentation
(for replicape and redeem only)

And anyone can contribute! Check out How To Contribute